Navigate back to parameter , open its configuration line, change its behavior setting to 2 (activates point selection execution), and click confirm.

The search results also reveal a completely separate "VISG" tool, which is likely the source of many "js-visg" search queries. This is a legacy software application designed to visually create Graphical User Interfaces (GUI) and then generate the source code for them in various programming languages. It was developed by Alexander G. Karpov (a.k.a. mrhx) and is open-source under the GPLv3 license.

Are you setting up a or a current (4-20mA) application?

, long-press the knob for 2 seconds. Use the knob to rotate to the desired parameter, then short-press to enter. Description Coarse/Fine Tune 0: Coarse, 1: Fine Adjustment. F002 Output Type 0, 1, 2, 3 Set Voltage/Current ranges (e.g., 0-10V, 4-20mA). F003 Display Mode 0: Real Value, 1: Percent (0-100%). F004 Calibration Calibrate output to match a multimeter. Accessing Advanced Parameters (Password)

This setup programs the device to toggle quickly between fixed calibration checkpoints (such as 4mA, 12mA, and 20mA) without needing to rotate through intermediate ranges.

To enter certain advanced parameter settings, users must rotate the knob to enter the password sequence: Wiring & Troubleshooting Connection Type Instruction Active Current Output to the signal input ( Voltage Output to the signal input ( Verification Test resistor to the output. The generator is working if Safety & Maintenance Lethal Voltage Warning:

ERROR: RESET FAILED. USER SYNCHRONIZATION AT 98%.

The JS-VISG-M-S is a single-unit photoelectric beam detector designed for indoor and outdoor perimeter protection. Unlike dual-unit beams (Transmitter/Receiver), this "M" (Mirror/Reflex) model functions by emitting an infrared beam that reflects off a prism reflector (sold separately or included) and returns to the unit. If the beam is blocked by an intruder, the alarm is triggered.

Connect (or positive) terminal to the positive terminal of the load.

Advanced configurations—such as changing display scales, limits, step changes, or calibration profiles—are managed via internal parameter submenus. Accessing System Settings

Bridge the controller’s analog ground return line back to the generator’s terminal. Passive 2-Wire Loop Simulation

// Import the module (ES6 syntax) import SceneManager, GeometryBuilder, ColorMap from 'js-visg-m-s';

Input the universal factory password string: (rotate clockwise one pulse, counter-clockwise one pulse, counter-clockwise one pulse, then clockwise one pulse).