Zclever Security Camera Manual [verified] Page

Connect one end of the Ethernet cable to the camera and the other end to a vacant LAN port on your home router.

Switch a "bad" camera to a known "good" port on the DVR to identify if the issue is the camera or the port. Motion Detection Not Working

Even with a perfect manual, technical hiccups occur. Here is a dedicated troubleshooting section for the most common Zclever challenges.

Plug the USB mouse into the front or back USB port of the recorder. zclever security camera manual

Locate the (usually a small button near the SD card slot or a reset wire on the camera pigtail cable).

: Ensure the DVR is connected to a monitor via HDMI or VGA for the initial configuration wizard. Default Credentials Username : admin . Password : Try leaving it blank (no characters). Other common defaults : 123456 , 000000 , or 12345 . How to Reset a Forgotten Password If you are locked out, try these recovery methods:

Draw specific boxes on the screen to monitor high-priority areas like doorways while ignoring busy sidewalks. Connect one end of the Ethernet cable to

Place indoor cameras on flat surfaces like shelves, desks, or refrigerators. If wall-mounting, attach the plastic base plate using the provided screws, then twist the camera base into the slots until it clicks. Outdoor Models

Increase the sensitivity if the camera is not picking up movement. 6. Maintenance Tips

Clean the camera glass cover with a microfiber cloth. Ensure the camera lens isn't pointing directly at a wall or gutter that reflects IR light back into the lens. Recorder lost internet connection. Here is a dedicated troubleshooting section for the

Located under a waterproof rubber flap for local storage.

Place the camera 8 to 10 feet above the ground to balance field of view and detail.

Ensure the DC adapter is properly connected to a working outlet. Connection Issue:

| LED Color/Behavior | Meaning | Action Required | | :--- | :--- | :--- | | | Booting up / Starting | Wait 30 seconds | | Flashing Red slowly | Standby mode (no Wi-Fi) | Ready to pair | | Flashing Red and Blue (or Red and Green) alternately | Pairing mode / AP mode | Add device in the app | | Flashing Blue quickly | Connecting to Wi-Fi | Wait | | Solid Blue | Connected and operational | Normal operation | | Off | Working (or powered off) | Check power cable |