This method attempts to reset the system clock and settings to factory defaults. Unplug the power and open the DVR cover.

After successfully resetting your Multistar DVR password, take these steps:

Locate and remove the small silver coin-cell (CMOS) battery from the motherboard.

Before performing a hard reset, try the standard factory default login information often used by Multistar and similar H.264 DVR manufacturers: (Leave blank), admin, 123456, or 888888 2. Physical Hardware Reset

Note: If the system allows you in, immediately change the password to something secure.

Method 2: The "Super Password" or "Date-Based Password" Method

Locate the small coin-cell battery on the motherboard. Unplug the DVR, remove the battery for at least 10–30 minutes, then reinsert it. This sometimes resets the system date to a default (e.g., 01-01-2000), allowing you to use a known default password for that specific date. Method 4: Contact Manufacturer Support How To Reset Multistar Dvr Password - Google Groups

If your motherboard does not feature distinct reset pins, resetting the internal clock forces the date-based security protocols to roll back to a default manufacturing state. Unplug the power cable from the DVR.

To reset a Multistar DVR password completely, you must either , apply a hard-reset technique via the motherboard CMOS battery, or generate an external super-password tied to the system clock . Because Multistar manufactures standalone H.264 DVR units built on generic hardware architectures, standard software-recovery routes differ heavily based on your specific model chassis.

If you can log in using one of the previous methods, you should reset the device to its factory settings to ensure no other old settings are present.

Many Multistar DVRs use a dynamic "super password" based on the system's current date.

Hold the reset button (or bridge the pins) and plug in the power. Hold for 30 seconds. Method 4: Removing the CMOS Battery

To reset your Multistar DVR password, follow these steps:

With the power on , press and hold the button for 10–30 seconds until the device beeps or reboots.

Go to the login screen and check the date displayed. It must be the exact date shown on the DVR.

Before attempting a hard reset, test these common default factory credentials for Multistar and similar H.264 DVRs:

Try leaving the password field completely blank , or enter 123456 , 888888 , 000000 , or admin . Method 2: The Super Password (Date-Based Generator)