Battery InstallationSlide the battery compartment cover off at the back of the unit.Connect a fresh 9V battery to the terminals.Replace the cover securely.
Q: Is the device accurate? A: Yes, the device has an accuracy of ±1/16 inch (±1.5 mm).
For accurate readings, ensure the base of the unit is flat against the starting wall. Quick Review: Pros & Cons
Use the button to increase or decrease the calibration value by millimeter increments (up to ±7mm). Press MEAS to save the calibration setting. Troubleshooting Error Codes Point-N-Measure Digital Tape W5746 User Manual
Blank ScreenThe battery is dead or installed incorrectly.The auto-off feature has engaged; press ON to wake the device.
The opening at the front of the unit from which the measuring beam or signal is emitted.
Before your first measurement, ensure you have fresh batteries installed (typically 2x AAA). For accurate readings, ensure the base of the
This device comes factory-calibrated. If you suspect structural drifting, test the unit against a known physical tape measurement of 10 feet. If it consistently reads incorrectly outside the tolerance limits, contact consumer support.
Do not use the tool in explosive atmospheres, such as in the presence of flammable liquids, gases, or dust.
A: The laser can be used outdoors, but its performance may be affected by bright sunlight. For best results, use it in shaded conditions or at close range. Troubleshooting Error Codes Blank ScreenThe battery is dead
| Parameter | Value | |-----------|-------| | Laser range | 0.5 – 130 ft (0.2 – 40 m) | | Laser accuracy | ± 1/16 in (± 1.5 mm) | | Tape range | 0 – 16 ft (0 – 5 m) | | Tape accuracy | Class II (± 1.2 mm over 5 m) | | Laser class | Class 2, 635 nm, <1 mW | | Battery | 3.7 V Li-ion, 400 mAh | | Auto shut-off | 180 sec (laser) / 300 sec (idle) | | Operating temp | 32°F – 104°F (0°C – 40°C) | | Weight | 8.5 oz (240 g) |
Clean the sensor lens with a soft, dry cloth; do not use liquid cleaners.Remove the battery if the tool will not be used for more than 30 days.Store in a cool, dry place away from direct sunlight. Contact Support
: The laser target surface is too dark or reflective. Use a white piece of paper or cardboard as a target target plate.
The Point-N-Measure W5746 features an onboard microprocessor that calculates area, volume, and indirect heights automatically. Press the button to cycle through these functions. Area Calculation (💾 Square Footage) Press MODE until the rectangle icon appears on the screen. Aim and press MEASURE to record the length. Aim and press MEASURE to record the width.
Press and hold the Power/Read button for three seconds. Alternatively, the device features an automatic shut-off function that powers down after two minutes of inactivity to preserve battery life. 4. Basic Operation & Single Distance Measurement