Alpha V1 Jet-em Manual

Replace all high-pressure internal O-rings, Teflon seals, and gaskets.

Regulates fluid delivery and pressure stabilization.

Draws raw fluids into the primary chamber via a dual-stage filtration screen. alpha v1 jet-em manual

The Control Unit interface allows you to build custom pulse profiles. Optimizing these three parameters is essential for high-yield operation: 1. Rise Time / Open Time (Open Width)

Submerge the nozzle plate, needle, and fluid chamber in an ultrasonic solvent bath for 10 minutes. Inspect the sapphire nozzle orifice under The Control Unit interface allows you to build

Check all structural bolts and hose clamps for correct torque.

Apply a low backpressure (0.02 MPa) via the controller interface and execute a manual purge until a continuous, bubble-free stream of fluid exits the nozzle. Step 2: Mechanical Stroke Calibration Inspect the sapphire nozzle orifice under Check all

Install the filter mesh cap, making sure it is properly seated to trap sediment. Stop Valve: Install the stop valve to control water flow. 3. Operating Instructions

Line Fault Indicator Detects and alerts of any false electrical connections with a red/ green indicator light. Alpha Home Appliances Sdn Bhd