Nokia G-010g-r Manual |best| Jun 2026

To enter factory reset mode, you must usually disconnect power, hold a specific internal jumper, or allow the device to fail to boot several times. Because the device is locked down for carrier use, the specific reset method may require opening the case and accessing the serial console.

| Specification | Detail | | :--- | :--- | | | G-010G-R | | Type | GPON ONT (SFU - Single Family Unit) | | Fiber Port | 1 x SC/APC (Green connector) | | LAN Port | 1 x Gigabit Ethernet (10/100/1000 Mbps) | | Power Supply | 12V DC, 0.5A or 1.0A (Check label) | | Voice (VoIP) | 1 x RJ11 (Phone port - model specific) | | Dimensions | 4.5” x 3.5” x 1.2” (Approx) | | Operating Temp | 0°C to 40°C (32°F to 104°F) |

Unplug and firmly re-seat the fiber connector until it clicks into place. 3. LAN LED is Off nokia g-010g-r manual

Restart the ONT and your router. Verify the Ethernet cable connection. 5.3 Low Speed Cause: Poor cabling or router issues.

Accepts 12V DC power from the provided AC adapter. LED Indicator Status Meanings Power Green (Solid) The device is powered on and functioning normally. The device is powered off or the outlet lacks electricity. Link / PON Green (Solid) To enter factory reset mode, you must usually

You will typically find the G-010G-R in use with major ISPs, including but not limited to:

Align the ridge on the cable connector with the slot on the ONT port. To enter factory reset mode

Green PON light = Good. Red LOS light = Call your ISP.

Changing settings (VLAN, PLOAM password, etc.) will kill your internet . Do not touch these unless you have the exact provisioning info from your ISP.

Disclaimer: This guide is for informational purposes. Firmware and ISP configurations vary. Always consult your Internet Service Provider for device-specific provisioning issues.

This is a common point of confusion. Unlike most home routers, the G-010G-R does not provide a full-featured graphical user interface (GUI) for you to configure.