Satlink Ws-6979 Software Upgrade ◆ (EASY)
After a successful upgrade, perform a factory reset (Menu → System → Factory Default) and then manually re-enter your preferred LNB settings. This clears any residual config data from the old firmware.
The device will restart automatically after a successful update. Troubleshooting and Crucial Tips
: A valid .bin or .img update file specifically for the WS-6979 model. Satlink Ws-6979 Software Upgrade
Updates may include better handling of H.265 (8-bit) content or new modulation types.
Ensure you are using firmware specifically designed for the WS-6979 or the WS-6979SE variant, as software for older models (like the WS-6906) is not compatible. After a successful upgrade, perform a factory reset
Power the Satlink while holding the Menu or Signal button (check the manual if this differs on your specific sub-model).
Moderate. Power failure or cable disconnection during the roughly 2-minute process can "brick" the device. Step-by-Step Upgrade Process Troubleshooting and Crucial Tips : A valid
Set the Upgrade Mode to or Software depending on the menu prompts.
Operating your signal meter on outdated software can lead to hardware inefficiencies and missed frequencies. Upgrading the firmware provides several critical benefits:
Use a high-quality USB 2.0 or USB 3.0 flash drive (ideally 16GB or smaller).