Xh-m608 Manual !!top!! -
The relay is usually rated for 10A . If you are running a heavy motor or a large inverter, use the XH-M608 to trigger a larger external contactor.
Charge control, discharge control, timing discharge, and voltage calibration. Physical: Approximately 66 x 46 x 16 mm; Weight ~80g. 2. Wiring and Setup
Connect the positive (+) and negative (–) leads of your 6-40V battery to the module's battery input terminals. Xh-m608 Manual
Manually verify the current battery voltage against your saved P2 and P3 settings. To help refine your setup, tell me:
The XH-M608 battery charge and discharge module is a highly versatile, affordable, and reliable solution for automatic battery management across a wide range of DC systems. Its built-in digital voltmeter, programmable thresholds, four operating modes, and integrated timer make it a valuable tool for solar installations, electric vehicles, battery backup systems, and electronics hobby projects. The relay is usually rated for 10A
Use or - to set the voltage where charging should stop (e.g., 14.4V for a 12V battery). Hold SET for 3 seconds to save. Setting Up Discharge Protection (Mode 2) Press SET . The display shows P1 . Press + or - to change the value to 2 . Press SET to access P2 (Lower voltage limit).
Set the module to CC mode. The battery powers the module via the Vin terminals. As long as the battery voltage is above P1 , the relay stays closed and powers the load. If the battery drops to P1 , the relay snaps open, protecting your battery from draining to zero. Troubleshooting & FAQ The module screen is blank. What is wrong? Physical: Approximately 66 x 46 x 16 mm; Weight ~80g
A: Yes, the module works well with 6-40V lithium batteries. Just set P1 and P2 according to your battery's specifications.
Ultimate XH-M608 Manual: Setup, Wiring, and Troubleshooting Guide
Sets timed charging/discharging duration:
Connect your charger or load here. The relay acts as a switch based on your voltage settings. 3. Menu Navigation (The "P" Settings) To enter the menu, short press SET to cycle through modes:
