Plug microphones into the XLR inputs and instruments into the line inputs.
Under , set Mic/Auxiliary Audio to Drembo M6 Audio .
Here’s a concise review of the based on typical user feedback and documentation standards for budget kitchen appliances:
Plug your primary microphone into Channel 1 using a balanced XLR cable. drembo m6 mixer user manual
Adjusts the output level of the headphone jacks without affecting the broadcast or recording volume.
While the Drembo M6 offers an extensive feature set for its price point, users should note specific performance characteristics often mentioned in its documentation. To minimize signal-to-noise ratios, it is recommended to use where possible, as 1/4" inputs may have lower gain and higher noise floors. Furthermore, although it has six input channels, it typically records to a computer in stereo (two channels) rather than providing independent multitrack outputs for each physical input. DEPUSHENG M6 6-Channel Sound Mixer User Manual
Enable the 48V Phantom Power if it's a condenser microphone. Plug microphones into the XLR inputs and instruments
Press the knob to select the desired effect (e.g., reverb or delay).
The stereo return allows you to return a stereo signal from an external processor or effect. To use the stereo return:
Attenuates input signals to minimize howling and feedback. Adjusts the output level of the headphone jacks
By following this user manual, you will be able to get the best performance out of your Drembo M6 Mixer
Use an official OTG adapter or dongle (e.g., Apple Lightning to 3.5mm adapter) connected to the auxiliary cable. Alternatively, some firmware versions allow a direct USB-C to USB-C digital connection via the OTG port.
Enabling the Ducking feature tells the internal DSP engine to constantly monitor Channel 1 and 2 inputs. The moment you speak into your microphone, the mixer automatically reduces the volume of Channels 3/4 and USB playback by a set number of decibels. The music returns to its original volume smoothly once you stop speaking. 4. Software Configuration & DAW Setup
Start with all GAIN and LEVEL knobs at minimum. Slowly increase the GAIN while speaking into the mic until you hear it clearly, then adjust the LEVEL for the final mix. 5. How to Use DSP Effects & Bluetooth Using the DSP Effects
: When you are finished, turn down the master volume and channel faders first. Then, power off the mixer.