If successful, you will drop into the prompt: BIOS#
execute factoryreset
[C]: Configure TFTP parameters. [R]: Review TFTP parameters. [T]: Initiate TFTP firmware transfer. [F]: Format boot device. [I]: System information. [B]: Boot with backup firmware and set as default. [Q]: Quit menu and continue to boot. [H]: Display this list of options.
Log in using the username admin and leave the password blank. fortigate 30d factory reset full
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
LED begins to blink slowly (usually 30–60 seconds after power-up), press and hold the reset button. Confirmation : Hold the button until the
Password: bcpb followed by the of your device (e.g., bcpbFGT30DXXXXXX ). Note: The Serial Number must be in all caps. If successful, you will drop into the prompt:
bcpb followed immediately by the Serial Number of your FortiGate 30D (e.g., bcpbFGT30DXXXXXXXXXX ). Note: The serial number letters must be in ALL CAPS.
For an factory reset that goes beyond configuration wipe:
Unplug the power adapter and wait for approximately 10 seconds. [F]: Format boot device
until you observe the status light change—typically from a slow blink to a faster blinking pattern. Hold for roughly 15 to 20 seconds.
Once reset, the default management IP address for the FortiGate 30D is 192.168.1.99 on internal interface ports. Method 1: Reset via the Command Line Interface (CLI)
The FortiGate 30D offers multiple paths to a full factory reset, ranging from the simple CLI command to the comprehensive TFTP reinstallation. Each method serves different scenarios: the CLI and GUI methods are ideal when you have basic access, the hardware button helps when credentials are lost, and TFTP recovery saves units that won't even boot.
Type and press Enter . The system will immediately clear its configuration register, flush its internal flash memory partitions, and initiate a hardware reboot. The reboot sequence typically takes between 2 to 5 minutes on the 30D hardware architecture.